1999-2007 Yamaha V Star 1100 3" Res-Tec Installation Instructions
download Stock Exhaust System Removal 1. Remove right side Foot peg assembly or Floorboard. (Whichever is applicable to your model.) 2. Remove O2 sensors from each muffler and cover with supplied cap...
View Article2007 Yamaha V-Star 1300 Classic Straights Installation Instructions
download Stock Exhaust System Removal 1. Remove right side Foot peg assembly or Floorboard. (Whichever is applicable to your model.) 2. Remove bolts that are holding pipes at rear mounting bracket. 3....
View ArticleSUZUKI M109 1800 cc EXHAUST SYSTEM INSTALLATION MANUAL
download 1. Remove the seat and right side fairing cover (with M109 insignia), behind the fuel tank. To remove the fairing, release the plastic peg on top by pushing the center inward and pulling the...
View ArticleKawasaki KFX KLX 400 Camshafts Installation Instructions
download Remove the plug bolt from the back of the cam chain tensioner assembly. It is under pressure from the spring. Remove the spring and pin. Remove the bolts and tensioner assembly from the...
View ArticleHarley-Davidson Twin Cam Engines Cam Chain Drive System Installation and...
download Removing the Cam Chain Drive System. NOTES Changing camshafts and cam drives in the 2006-up Harley-Davidson® Twin Cam 88® engines is different than in pervious engines. Procedures require use...
View ArticleHow to Replacing Rear Main Seal 1
download The next day I woke up early and drank lots of coffee before going out to the garage. I knew I had two distinct problems confronting me. First, I would have to purchase an impact tool in order...
View ArticleHarley-Davidson Twin Cam Engines Performer RPM Gear Drive Camshaft Kit...
download 1. Disconnect the battery, and remove the fuel tank. 2. On engines with the oil tank above the engine, drain the engine oil. 3. Remove the front exhaust pipe to clear the Cam Housing Cover. 4....
View ArticleYamaha YZ400/426F Camshafts REMOVAL AND INSTALLATION MANUAL
download Cleanliness is always a good place to start. Make sure the motorcycle is cleaned thoroughly before you start. It would be advisable to use an engine degreaser on the frame and the engine. This...
View ArticleYamaha YZ 250F Camshafts REMOVAL AND INSTALLATION MANUAL
download Remove the 4 bolts that hold the exhaust cam cap in place, lift the cam cap off. It may be necessary to pry very lightly on the cap to lift it off its dowel pins. Do not use the cam lobes as...
View ArticleHARLEY DAVIDSON HYBRID CAM PLATE AND HIGH FLOW OIL PUMP KIT REMOVAL AND...
download REMOVAL To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect battery cables (negative (-) cable first) before proceeding. (00307a) Disconnect negative...
View Article
